Fill Dirt in Pinetop-Lakeside, AZ

Local prices vary with haul distance and volume, but in Pinetop-Lakeside fill dirt typically runs about $25 to $45 per ton (or per cubic yard) delivered. Hello Gravel works with local haulers and has a minimum order of 3 tons; standard delivery is 2+ business days and next-day delivery is available for an extra fee when ordered before noon CST. Check availability for your zip code at checkout.

Use the rule of thumb: cubic yards = area (sq ft) * depth (in) / 324. For 1,000 sq ft that is about 3.1 cu yd for 1 inch, 6.2 cu yd for 2 inches, 9.3 cu yd for 3 inches, and 12.4 cu yd for 4 inches. At local delivered prices of roughly $25 to $45 per cubic yard, expect material costs of about $230 to $420 for 3 inches, and about $310 to $560 for 4 inches, not including spreading or compaction.

A typical example: a 20 ft wide by 50 ft long driveway is 1,000 sq ft. If you install a 4 inch compacted fill-dirt base (about 12.4 cu yd) and 3 inches of gravel topping (about 9.3 cu yd), material costs in Pinetop-Lakeside are roughly $700 to $900 for both materials at local rates. Add hauling, compaction, and labor and you can expect total installed costs commonly in the $1,500 to $3,500 range depending on site access, grading, permit needs, and contractor rates.

Fill dirt is generally cheaper per cubic yard and is the right choice when you just need to raise or level grade. For long-term surface use (paths, driveways, or areas that need drainage and wear resistance), gravel or a compacted granular base is better. Many contractors recommend compacted fill dirt for the subgrade and a granular layer on top to manage drainage and reduce frost heave.

You should not just dump gravel over loose or organic dirt and expect long-term performance. Proper installation usually includes removing organic topsoil where needed, adding compactable fill or aggregate base, compacting it in lifts, and then placing the gravel surface; geotextile fabric is often used in wet or soft spots. Drivers may offer tailgate spreading at their discretion when requested at checkout, but full base prep and mechanical compaction are typically done by contractors and add to the project cost.

Use this formula: cubic yards = area (sq ft) * desired depth (in) / 324. As an example, a 500 sq ft area raised 3 inches needs about 4.6 cu yd. For tonnage, a practical rule of thumb for fill dirt is about 1.2 tons per cubic yard (varies with moisture and composition), so multiply cubic yards by 1.2 to estimate tons and then round up for waste and settlement.

Rules vary by municipality and HOA. Pinetop-Lakeside may require permits for significant grading, driveway reconstruction, or changes to drainage; HOAs often have restrictions on visible surface materials and driveway appearance. Before ordering bulk fill dirt for large jobs, contact the town planning department and your HOA to confirm permit and material requirements.

Contractors in the White Mountains prefer clean, low-organic fill or select fill that compacts well and drains, because Pinetop-Lakeside's freeze/thaw and snow conditions increase frost-heave risk. For driveways and load-bearing areas, a granular class II or crushed base under a gravel surface is commonly recommended. Topsoil or high-organic fill is fine for planting but should not be used where a stable base is needed.

Hello Gravel coordinates delivery only; drivers may offer tailgate spreading at their discretion if requested at checkout, but this is not guaranteed. Full spreading and compaction are usually provided by local landscapers or sitework contractors; prices vary with equipment, scope, and access. Ask suppliers or local contractors for itemized quotes for spreading and compaction so you can compare material delivery versus full-install bids.

Yes. Pinetop-Lakeside experiences snow, freezing temperatures, and spring thaw, which affect material handling and compaction. Wet or frozen ground makes compaction difficult and may delay installs or increase costs; deliveries can be delayed by winter weather. For best results, schedule major grading in late spring through early fall and choose well-draining fill to reduce frost heave risks.

As of today, we require 2 business days for delivery.

Use our material calculator here: https://hellograve3dev.wpengine.com/calculator/ to enter the length, width and depth measurements of your project. It will automatically calculate the cubic yards/tons needed. If you are unsure how much to order, contact our team for guidance.

Please type in your zip code on any product screen and it will let you know if we service your area. The chances are that we do!

The material will be delivered via dump truck. If your order is under 20 tons, then it will likely be just one dump truck load. If your order is more than 20 tons, it will be more than one dump truck load.

Absolutely! Try our aggregate quiz here: https://hellograve3dev.wpengine.com/aggregate-quiz/ Alternatively,you can call us, chat with us (box in the bottom right corner of the website), or email us!

We cannot get out of the truck and manually spread it. However, depending on the location, safety, and comfortability of the driver – we may be able to tailgate spread your material. This involves pulling the truck forward as material is being dumped to make it easier for you to distribute material after delivery.

The minimum order size is 3 tons.

Hassle Free! Our goal is to make the buying process for gravel and other aggregates as easy and seamless as possible. Enter your zip code on our site, select how much material you need (see below FAQ’s to determine order size), select the date and time frame you would like your material delivered at Checkout, and place your order with any major credit card. After the order is placed our in-house support team will contact you to confirm the details. We will send additional confirmations on the day before and the day of delivery. On delivery day, a dump truck will arrive to dump the materials at your specified location. We request that you have someone available to accept the delivery so that we can make sure to dump it in the correct location. That’s it!

No, because we are a national supplier, we utilize our existing network of suppliers across the country. Therefore, the materials will likely be delivered from a contracted trucking company.

We specialize in making the aggregate buying process as easy and seamless as possible by managing the process from end to end. We have a network of suppliers that we source the materials from where we have negotiated rates. However, we do charge a markup and because of this you may be able to find the materials cheaper on your own. But if you want a hassle free experience, then we are for you!

Please fill out the Quote Request form and we will work up a quote for you! https://hellograve3dev.wpengine.com/quote-form/

Although uncommon, due to regional sourcing, the type and color of our materials may vary somewhat from the images on our website, reflecting the unique geological offerings of your area. Please communicate any specifications you desire to our team so we can consider them during the sourcing process.

Please contact our customer service team promptly if you experience any delivery or product quality issues. We will work to resolve them satisfactorily.

We are headquartered in New Orleans, LA. However, we have a network of suppliers across the country from which we provide the materials.